Safety Information; Step 1 - Installation - Warmup 6iE User Manual

Safety Information

The 6iE must be installed by a qualified electrician. It requires a
q
permanent 110V - 240V AC, 60Hz supply. The 6iE contains a Class A
GFCI with 5mA trip level and wiring must conform to local electrical
code.
Isolate the 6iE from the mains supply throughout the installation
q
process.
Conduits are only required where it is mandated by state or
q
provincial code. Please refer to local electrical code for compliant
applications.
The 6iE and its packaging are not toys; do not allow children to
q
play with them. Small components and packaging present a risk of
choking or suffocation.
The 6iE is suitable for indoor use only. It must not be exposed to
q
moisture, vibrations, mechanical loads or temperatures outside of its
rated values.
For safety and licensing reasons unauthorised change and/or
q
modification of the 6iE is not permitted.
Ensure the distance from your router to the 6iE is not excessive.
q
This will ensure the wireless connection is not subject to range or
interference issues once installed.
Install the 6iE in an area with good ventilation. It should not be
q
beside a window/door, in direct sunlight or above another heat
generating device (e.g. radiator or TV).

Step 1 - Installation

1
Isolate the 6iE and supply from
the mains supply.
3
Install a 3-1/2" (89 mm) deep single gang or 2-gang box with mud ring
in your preferred thermostat location. Pull wires (heater, supply and
sensor) through gang box and complete terminal wiring.
2
Unclip the display from the
power base and remove the
display
3