Table of Contents
Advertisement
V
P
—Press
ERTICAL
OSITION
up.
F
—Allows you to change the display data clock frequency to match the
REQUENCY
frequency of your computer graphics card. If you see a vertical flickering wave, use
Frequency control to minimize the bars. This is a coarse adjustment.
T
—Allows you to synchronize the phase of the display signal with the
RACKING
graphic card. If you experience an unstable or flickering image, use Tracking to
correct it. This is a fine adjustment.
DISPLAY (in Video Mode)
Using the Display menu, you can adjust the display settings of your projector. The
Display menu provides the following options:
V
M
—Allows you to optimize the projector's display mode:
IDEO
ODE
Presentation, Bright, Movie, sRGB (provides a more accurate color
representation), and Custom (set your preferred settings for these two options). If
you adjust the settings for White Intensity or Degamma, the projector
automatically switches to Custom.
S
T
—Manually select the signal type: RGB, YCbCr, or YPbPr.
IGNAL
YPE
Z
—Press
to digitally magnify an image up to 8 times on the projection
OOM
screen and press
Z
N
—Press
OOM
AVIGATION
W
I
—Set 0 to maximize the color reproduction and 10 to maximize
HITE
NTENSITY
the brightness.
D
—Adjust among the 4 preset values (1, 2, 3, 4) to change the color
EGAMMA
performance of the display.
to move the image down and
to reduce the zoomed image (for single display).
to navigate the projection screen.
Using Your Projector
to move the image
36
Advertisement
Table of Contents
