Table of Contents
Advertisement
®
R&S
NRPM
5
R&S NRPM tour
The following chapters introduce the main hardware components of the
R&S NRPM OTA power measurement solution.
5.1
R&S NRPM3(N) sensor modules
The R&S NRPM3(N) three-channel sensor module processes the measured val-
ues from up to three antenna modules in three separate channels.
This chapter provides an overview of the available connectors and LEDs of the
R&S NRPM3(N) sensor modules.
the left, and the USB sensor module on the right.
Figure 5-1: R&S NRPM3N and R&S NRPM3
1 = Antenna connector, see
2 = Status LED, see
3 = Host interface connector, see
4 = Trigger I/O connector, see
5 = Network status LED, see
6 = LAN connector, see
7 = LAN reset button, see
8 = Power over Ethernet status LED, see
User Manual 1425.8663.02 ─ 07
"Antenna connector (1)"
"Status LED (2)"
on page 29
"Host interface connector (3)"
"Trigger I/O connector (4)"
"Network status LED (5)"
"LAN PoE interface (6)"
"LAN reset (7)"
R&S NRPM3(N) sensor modules
Figure 5-1
shows the LAN sensor module on
on page 29
on page 30
on page 30
on page 30
on page 30
"Power over Ethernet status LED (8)"
R&S NRPM tour
on page 29
on page 31
28
Advertisement
Chapters
Table of Contents
