Table of Contents
Advertisement
Installation
The MBTCP Gateway Module is available for use with
all GCA-based systems that have a compatible design.
Each MBTCP module requires the following to operate
in a system:
•
Mounting hardware
•
Compatible GCA system
Install the MBTCP module as explained in the system
operation manual or in the installation kit manual.
If the MBTCP is offered only as an accessory for your
system, see Accessories in the system operation man-
ual for available MBTCP kits.
Install or Update Software
NOTE: The fieldbus connection is temporarily disabled
during the installation or update of software.
1. Ensure system is inactive.
2. Remove access cover (E)
S
F
. 2
IG
334183B
3. Insert and press software token (T) firmly into slot.
L
S
F
. 3
IG
4. Press the reset push button (M) once. Wait for red
light (L) to stop flashing. This may take up to 30 sec-
onds
5. Remove Token (T). Store in a safe place.
6. Replace access cover (E).
Connect Cables
E
Connect cables as explained in the system operation
manual.
Route cables to avoid interference with moving
parts.
M
T
NOTICE
Installation
5
Advertisement
Table of Contents
