Packing For Shipment; General Instructions; Repacking In Original Carton - Mallinckrodt Nellcor N-20 Service Manual

7 PACKING FOR SHIPMENT

7.1 General Instructions

7.2 Repacking in Original Carton

7.3 Repacking in a Different Carton
Should you need to ship the N-20/N-20P monitor for any reason, follow the instructions in this
section.
7.1 General Instructions
Pack the monitor or printer carefully. Failure to follow the instructions in this section may result in
loss or damage not covered by the Mallinckrodt warranty. If the original shipping carton is not
available, use another suitable carton or call Mallinckrodt Technical Services to obtain a shipping
carton.
Prior to shipping the device, contact Mallinckrodt Technical Services for a returned goods
authorization (RGA) number. Mark the shipping carton and any shipping forms with the RGA
number.
7.2 Repacking in Original Carton
If available, use the original carton and packing materials. Pack the monitor or printer as follows:
Place the monitor, or printer, and, if necessary, accessory items in original packaging.
Place in shipping carton and seal carton with packing tape.
Label carton with shipping address, return address, and RGA number.
7.3 Repacking in a Different Carton
If the original carton is not available:
1. Place the monitor or printer in plastic bag.
2. Locate a corrugated cardboard shipping carton with at least 200 pounds per square inch (psi)
bursting strength.
3. Fill the bottom of the carton with at least 2 inches of packing material.
4. Place the bagged unit on the layer of packing material and fill the box completely with packing
material.
5. Seal the carton with packing tape.
6. Label carton with shipping address, return address, and RGA number.
7-1