Administrator Settings - D-Link DIR-412 User Manual

Section 3 - Configuration
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management. There are
two accounts that can access the management interface through the web browser. The accounts are admin and user. Admin
has read/write access while user has read-only access. User can only view the settings but cannot make any changes. Only the
admin account has the ability to change both admin and user account passwords.
Admin Password:
Enter and confirm a new password for the Administrator
Login Name. The administrator can make changes to the
settings.
Enable Graphical
Check this box to enable graphical authentication. The
Authentication:
device supports this function to prevent phishing.
Enable Remote
Remote management allows the DIR-412 to be configured
Management:
from the Internet by a web browser. A username and
password is still required to access the Web-Management
interface. In general, only a member of your network can
browse the built-in web pages to perform Administrator
tasks. This feature enables you to perform Administrator
tasks from the remote (Internet) host.
Remote Admin
The port number used to access the DIR-412.
Port:
Example: http://x.x.x.x:8080 whereas x.x.x.x is the Internet
IP address of the DIR-412 and 8080 is the port used for the
Web Management interface.
D-Link DIR-412 User Manual

Administrator Settings

54