Table of Contents
Advertisement
8.1 Trouble shooting
When the appliance control system detects a fault, it is indi-
cated on the display with a spanner symbol, possibly together
with a fault code.
The appliance makes a distinction between a fault at which the
appliance keeps running (limitedly and a serious (locking fault
at which the fan is switched o .
In case of locking fault, the settings and readings menu is swit-
ched o as well and only the service menu is available.
The appliance remains in this fault mode until the problem in
question has been solved. Then the appliance will reset itself
(auto reset and the display will once more show the operating
mode.
Fault E999
If message E999 appears on the display directly when the ap-
pliance is powered up, the control pcb is not suitable for this
appliance or the dip switches on the control pcb are set incor-
rectly.
For the location of the dip switches on the board, see §10.1.
In that case, check whether the dip switches on the control pcb
are set as shown in the drawing of the dip switch settings; if
they are, and the message E999 still appears, then replace the
control pcb by a pcb of the correct type.
How to access the pcb is described in §9.2 item 1 - 6.
8.2 Display codes
Non-locking fault
When the appliance detects a non-locking fault, it will still keep
running (limitedly . The display does show the fault symbol
(spanner .
Locking fault
When the appliance detects a locking fault, it will no longer
work. The (permanently lighted display shows the fault symbol
(spanner together with a fault code (see table next page . The
red LE on the multiple switch (if applicable will be blinking.
Contact the installer to remedy this fault. A locking fault cannot
be remedied by taking the voltage from the appliance; rst the
fault must be solved.
Elan 10 2.0 / Elan 16 2.0 / Elan 25 2.1
Elan 10 2.0
ON
Elan 16 2.0
ON
Elan 25 2.1
ON
614391-F
21
Advertisement
Table of Contents
