Conversion To Own Ow Version; Water Connections; Connecting Ducts - Brink Elan 10 2.0 Installation Instructions Manual

5.4 Conversion to Up ow version
An Up ow Elan appliance can easily be converted to an Elan
own ow appliance.
Open both lter doors
Unscrew 4 screws (Torx T20 that hold the front panel
with the doors and take out this panel so the control panel
with the mounting bracket is accessible.
Unscrew the two screws (Torx T20 that hold the control
panel to the front panel and rotate this control panel 180
degrees.

5.5 Water connections

The heat exchanger in the air heater is connected with 22 mm
connectors (both compression tting and soldered tting are
possible .
It is recommended to place stop cocks with couplings directly
on the outside of the appliance in the input as well as the input
lines.
Use one of the breakout tabs for feeding through the water li-
nes. The water connections can be routed out of the appliance
on the left or on the right.

5.6 Connecting ducts

Standard manifolds are available for the Elan series.
For an Up ow these are placed on the appliance and for a
own ow they are placed under the appliance. The hot air
ducts are connected to this manifold.
Observe the following items when connecting the ducts.
Install (if necessary a control valve in every branch of the
manifold or the main duct.
Always lay out return ducts in such a manner that they do
not become sound bridges, so no straight connections bet-
ween two rooms.
Insulate all hot air ducts including the grill adapters and the
exterior air duct.
.
4x Torx T20
2x Torx T20
Elan 10 2.0 / Elan 16 2.0 / Elan 25 2.1
Rotate the entire Elan appliance 180 degrees.
Remount the front panel with the doors with the four screws.
The appliance is now a own ow version.
When using a compression tting, always use a support bush
Ø 22 mm when making the water connections.
When mounting exible ducts, bear in mind that it must be
possible to replace them in due course.
Place a moisture barrier around the insulation material to
prevent condensation.
Always lay out return ducts in such a manner that they do
not become sound bridges, so no straight connections bet-
ween two rooms.
Connecting the return: Connect the return duct to the return
air or the installation room. An acoustic return plate is avai-
lable for an appliance with open return.
Provide the exterior air connection with a control valve and
connect it to the return duct.
614391-F
Water connection
11