New Holland Speedrower 200 Service Manual page 14

Operator presence system
Your machine is equipped with an operator presence system to prevent the use of some features while the operator
is not in the operator's seat.
The operator presence system should never be disconnected or bypassed.
If the system is inoperable, the system must be repaired.
Power Take-Off (PTO)
PTO-driven machinery can cause death or serious injury. Before working on or near the PTO shaft or servicing or
clearing the driven machine, put the PTO switch in the disengage position, stop the engine, and remove the key.
Whenever a PTO is in operation, all guards must be in place to prevent death or injury to the operator or bystanders.
Reflectors and warning lights
Reflectors are located on the handrails in the areas as shown in Figure 1.
Flashing amber warning lights must be used when operating on public roads.
Seat belts
Seat belts must be worn at all times.
Seat belt inspection and maintenance:
• Keep seat belts in good condition.
• Keep sharp edges and items than can cause damage away from the belts.
• Periodically check belts, buckles, retractors, tethers, slack take-up system, and mounting bolts for damage and
wear.
• Replace all parts that have damage or wear.
• Replace belts that have cuts that can make the belt weak.
• Check that bolts are tight on the seat bracket or mounting.
• If belt is attached to seat, make sure seat or seat brackets are mounted securely.
• Keep seat belts clean and dry.
• Clean belts only with soap solution and warm water.
• Do not use bleach or dye on the belts because this can make the belts weak.
To fasten the belt, pull it from the reel and push the tongue end (3) into the buckle end (2) until a "click" indicates it is
fully engaged.
INTRODUCTION
1
86070769
47698329 14/04/2014
10