RH Teen NILSSON BED FULL AND QUEEN Assembly Instructions

NILSSON BED FULL AND QUEEN - ASSEMBLY INSTRUCTIONS
PARTS INCLUDED
A.HEADBOARD (1)
B.SIDE RAILS (2)
C.FOOTBOARD (1)
D.CENTER SLATS (4)
E.PLATFORMS (2)
F.CENTER SLAT FEET
(WITH ADJUSTABLE GLIDE) (2)
PART S INCLUD ED
Philips-Head Screwdriver (not included)
ASSEMBLY IN STRUCTION S
 Bed must be assembled by at least two people.
 Please read instructions carefully before assembling bed.
 Use the above parts and hardware list to identify each component.
 Keep all packing materials until assembly is complete to avoid loss of smaller parts
1.
Stand the Headboard (A) upright and attach Side Rails (B), as shown in Diagram I.
2.
Lock the Footboard (C) and Side Rail (B) with Thread Rod (4), Curved Washers (5), Lock Washers (6) and Nuts (7),
then tighten with Spanner Wrench (8), as shown in Diagram II.
3.
Attach the Center Slat Feet (F) to the Center Slat (D), as shown in Diagram III.
4 Place the Center Slat (D) on the top of the Side Rail' s (B) side slate and fasten using Screw (2), as shown in
Diagram IV.
5. Lay the Platform (E) on the top of the side slates, then screw with Screw (3), as shown in Diagram V.
ITEM ITEM
NO. NO. DESCRIPTION DESCRIPTION
Allen Key (0.5cm)
1
2
3
4 Thread Rods (0.8cm Dia.)
Curved Washers
5
Lock Washers
6
7
Spanner Wrench
8
1 of 2
Screws (4cm)
Screws (3cm)
Nuts
QTY QTY
. . . , . 1 pc
.
8 pcs. . . . . . . .
.
16 pcs
.
4 pcs
.
4 pcs
.
4 pcs
.
4 pcs
.
1 pc
.