RH Teen NILSSON TWIN BED Assembly Instructions

NILSSON TWIN BED - ASSEMBLY INSTRUCTIONS
PART S INCLUD E
A. HEADBOARD (1)
B. SIDE RAILS (2)
C. FOOTBOARD (1)
D. SLATS (4)
E. PLATEFORM PANELS (2)
PART S INCLUD ED
Phillips- - - - - - Head Screwdriver (not included)
ASSEMBLY IN STRUCTION S
 Bed must be assembled by at least two people.
 Please read instructions carefully before assembling bed.
 Use the above parts and hardware list to identify each component.
 Keep all packing materials until assembly is complete to avoid loss of smaller parts
1.
Stand the Headbaord(A) upright, attach the Side Rails (C) into the Headboard(A),do not tighten the
Allen Head Bolts (3) until the bed is fully assembled, as shown in Diagram ÿ I .
2.
Lock the Footboard (C) & Side Rail (B) with Thread Rod (4), Curved Washers (5), Lock Washers (6) and Nuts (7),
then tighten with Spanner Wrench (8), as shown in Diagram II.
3.
Place the Slats (D) on the top of the Side Rail' s (B) side slate and fasten using Screw (2), as shown in
Diagram III.
4. . Lay the Platform (E) on the top of the side slates then tighten the screw (3), as shown in Diagram IV.
ITEM ITEM
NO. NO.
Allen Key(0.5cm)
1
2
3
4 Thread Rod(0.8cm Dia)
Curvead Washer
5
6
7
Spanner Wrench
8
1 of 2
DESCRIPTION DESCRIPTION
Screw(4cm)
Screw(3cm)
Lock Washer
Nut
QTY QTY
1 pc
8 pcs
16 pcs.
4 pcs
4 pcs
4 pcs
4 pcs
1 pc