Advertisement
Quick Links
INSTALLATION AND OPERATION INSTRUCTIONS
T261/ T264 ICE CRUSHERS
A Tradition of Excellence In ICE Equipment
KOLD-DRAFT
1525 East Lake Road
Erie, PA 16511-1088
PH: 800-840-9577 FAX: 800-548-9392
© 2009 KDIndustries, Inc. Erie, PA U.S.A.
LIT 508 1035 01 Rev 5/09
Printed in U.S.A.
Advertisement
Related Manuals for Kold-Draft T261
Summary of Contents for Kold-Draft T261
- Page 1 INSTALLATION AND OPERATION INSTRUCTIONS T261/ T264 ICE CRUSHERS A Tradition of Excellence In ICE Equipment KOLD-DRAFT 1525 East Lake Road Erie, PA 16511-1088 PH: 800-840-9577 FAX: 800-548-9392 © 2009 KDIndustries, Inc. Erie, PA U.S.A. LIT 508 1035 01 Rev 5/09...
-
Page 2: Installation
{ Warn all users to clean up spillage immediately, keep storage bin doors closed, and report any apparent leakage or unusual sounds to maintenance personnel. ® { Proper installation must include KOLD-DRAFT GB Series Ice Cuber mounted above Crusher. INSTALLATION NOTE: Refer to ice cuber instructions before proceeding. - Page 3 T261/T264 Crusher Installation Instructions 2. Level the bin with adjusters on legs, or by shimming if the bin is to sealed to the floor. If gaps due to shims are greater than 1/8 inch, install a cove molding around the bin bottom.
- Page 4 T261/T264 Crusher Installation Instructions 7. Install gasketing on top of crusher. (See Illustration "B"). 8. Remove the cuber cabinet panels, lift and position cuber on top of gasketed crusher and align mounting holes. Install cap screws, lock washers and nuts.
- Page 5 T261/T264 Crusher Installation Instructions CRUSHER BOTTOM GUARD INSTALLATION INSTRUCTIONS NOTE – IF POSSIBLE, INSTALL THE GUARD BEFORE THE CRUSHER IS MOUNTED ON A BIN. FRONT CUTAWAY VIEW OF CRUSHER MECHANISM 9. Place the crusher on a flat surface, Then stand the unit on its left side.
- Page 6 T261/T264 Crusher Installation Instructions ® The crusher is designed to operate in conjunction with one or two Kold-Draft cubers. Two motor control relay blocks are provided and a relay coil must be installed for each cuber used. Each relay coil must have a voltage rating matching the voltage of the ice cuber, regardless of the crusher motor voltage.
- Page 7 T261/T264 Crusher Installation Specifications 16. The bin thermostat in the cuber must be disabled and replaced by the two thermostatic switches in the crusher. (See Wiring Diagram). 17. The crushed ice thermostat (Left) cap tube is placed into the straight thermostat tube holder.
- Page 8 Crushers are intended for indoor use only with permanent connection to a field electrical supply. ® ® All models are intended to be installed only in conjunction with Kold-Draft cubers on Kold-Draft bins. CRUSHER OPERATION With the crusher knob in the "CRUSHED" position, ice falling from the cuber will be directed by the selector plate through the crusher mechanism and deposited into the left side of the bin.
- Page 9 2. Check the belt and pulleys for excessive wear. Adjust the belt tension to deflect 5/32 inch with two pounds applied to the center of the span. 3. Tighten any loose set screws, machine screws, nuts and electrical connections. ® Pg 8 Kold-Draft Service & Parts Manual...
- Page 10 Wiring Diagram ® Pg 9 Kold-Draft Service & Parts Manual...
Need help?
Do you have a question about the T261 and is the answer not in the manual?
Questions and answers