PROAIM CINEMA Series Assembly Manual page 2

Airwave V530 Setup

Attach your Airwave Arm with Pole via clamps
and tighten knobs to secure it properly.
Spring Adjustment
NOTE: Load Capacity can be easily adjusted by
adjusting springs. Adjust both springs equally.
Airwave parallel with the ground gives the best
performance.

Loosen springs for lower setup weights &
tighten them for higher setup weights.

In order to smoothen Dampening effect, turn
the adjustment knob. If the arm is too soft,
turn it towards direction of H (Hard). If the
arm is rigid turn it towards the direction of
S (Soft).
NOTE: The valves should always be adjusted
evenly and set identically. Rebound and
compression of the hydraulic valves should be
set in such a way so that any loose swinging or
vibration of the arm is eliminated.
Attaching Isolator Section

Loosen the bolt with allen key and remove
L-plate from the Airwave.

Now attach the Isolator Section with Airwave
Arm. Then tighten these bolts with Allen key
to secure properly.
2