Advertisement
2. Position the sensor vertically on the wall, 4 feet (1.5 m) above the floor. Place so that the "Install This End Up" statement
on the board is in the upper right corner.
3. Mount the backplate onto the wall using the screws provided.
4. Wire the backplate. Connect the wires to the screw terminals. Do not over-tighten the screws.
1
Document Part # 026-4858 Rev 0
©2021 Emerson Digital Cold Chain, Inc. This document may be photocopied for personal use.
Visit our website at www.climate.emerson.com for the latest technical documentation and updates.
2
Page 3 of 7
Advertisement
