Mitsubishi Electric PQHY-P200YHM-A Data Book page 14

Model
Power source
Cooling capacity
( N o m n i a ) l
Power input
Current input
COP
Temp. range of Indoor
cooling Circulating water
Heating capacity
(Nominal)
Power input
Current input
C O P
Temp. range of Indoor
heating Circulating water
Indoor unit Total capacity
connectable Model / Quantity
Sound pressure level (measured in anechoic room)
Refrigerant Liquid pipe
piping diameter Gas pipe
Set Model
Model
Circulating Water flow rate m
wate r
Pressure drop
Operating volume range
Compressor Type x Quantity
Manufacture
Starting method
M t o r o o u p t
C a s e h e t a r e
Lubricant
External finish
External dimension HxWxD
Protection High pressure protection
devices
Inverter circuit (COMP.)
Compressor
Type x original charge
Refri gerant
Control
N t e w e g i t h
Heat exchanger
Water volume in plate
Water pressure Max.
HIC circuit (HIC: Heat Inter-Changer)
Liquid pipe
Pipe between unit and
Gas pipe
distributor
Drawing External
Wiring
Document
Standard attachment
Accessory
Optional parts
Remarks
●Turn DipSW 3-9 ON before power ON.
●Details on foundation work, duct work, insulation work, electrical wiring, power source switch, and other items shall be refer
●Due to continuing improvement, above specifications may be subject to change without notice.
●The ambient temperature of the heat source unit needs to be kept below 40 °C D.B.
●The ambient relative humidity of the heat source unit needs to be kept below 80%.
●The heat source unit should not be installed at outdoor.
●Be sure to mount a strainer (more than 50 meshes) at the water inlet piping of the unit.
●Be sure to provide interlocking for the unit operation and water circuit.
●Add brine to circulating water when a unit is operating at water temperature below 10°C.
●Twinning kit is required.
Notes:
1.<Standard CITY MULTI indoor unit>
Nominal cooling conditions(subject to JIS B8615-1)
Indoor:27°CDB/19°CWB(81°FDB/66°FWB)
Water temperature:30°C(86°F)
Pipe length:7.5m(24-9/16ft.), Level difference:0m(0ft.)
Brine concentration 0%
2.<PWFY-P100/200VM-E-AU>
Nominal cooling conditions
Circulating water Temp. : 30°C (86°F)
Pipe length : 7.5 m (24-9/16 ft)
Level difference : 0m (0ft)
Inlet water Temp 23°C
3
Water flow rate : 1.93m /h (P100) / 3.86m
Brine concentration 0%
*1 kW
*1 c k a / l h
*1 BTU / h
kW
A
kW / kW
W.B.
°C
kW
*2
*2 kcal / h
*2 BTU / h
kW
A
kW / kW
D.B.
°C
dB <A>
mm(in.)
mm(in.)
PQHY-P250YHM-A(For Ground source)
3
/ h
L/min
cfm
kPa
3
m / h
Inverter scroll hermetic compressor
AC&R Works, MITSUBISHI ELECTRIC CORPORATION AC&R Works, MITSUBISHI ELECTRIC CORPORATION
t u k W
k W
Acrylic painted steel plate
mm 1,160(1,100 without legs) x 880 x 550
in. 45-11/16(43-5/16 without legs) x 34-11/16 x 21-11/16
High pressure sensor, High pressure switch at 4.15MPa (601 psi)
Over-heat protection, Over-current protection
k ( g b l ) s
l
MPa
mm(in.)
mm(in.)
Nominal heating conditions(subject to JIS B8615-1)
Indoor:20°CDB(68°FDB)
Water temperature:20°C(68°F)
Pipe length:7.5m(24-9/16ft.), Level difference:0m(0ft.)
Brine concentration 0%
Nominal heating conditions
Circulating water Temp. : 20°C (68°F)
Pipe length : 7.5 m (24-9/16 ft)
Level difference : 0m (0ft)
Inlet water Temp 30°C
3
/h (P200) Water flow rate : 2.15m
Brine concentration 0%
PQHY-P500YSHM-A(For Ground source)
3-phase 4-wire 380-400-415V 50/60Hz
48,200
191,100
11.45
19.3-18.3-17.6
15.0~24.0°C(59~75°F)
-5.0~45.0°C(23~113°F)
54,200
215,000
12.06
20.3-19.3-18.6
15.0~27.0°C(59~81°F)
-5.0~45.0°C(23~113°F)
50~130 % of heat source unit capacity
P15~P250 / 1~43
15.88(5/8) Brazed
28.58(1-1/8) Brazed
5.76 + 5.76
96 + 96
3.4 + 3.4
1 7
4.5 + 4.5 ~ 7.2 + 7.2
Inverter
6 3 .
0 0 . 3 5 2 ( 4 0 ) V
M E L 3 2
Over-heat protection
R410A x 5.0kg (12lbs)
Indoor LEV and BC controller
195(430)
p a l e t y t p e
5.0
1.0
-
9.52(3/8) Brazed
2 2 ( 2 . / 7 ) 8 B a r e z d
KB94T223
KE94C317
Installation Manual
Refrigerant conn. pipe
Heat Source Twinning kit: CMY-Y100VBK2
Joint: CMY-Y102S-G2, CMY-Y102L-G2, CMY-Y202-G2
Header: CMY-Y104/108/1010-G
3 3
/h (P100) / 4.30m /h (P200)
- 10 -
56.0
4.89
63.0
5 2 . 2
52
PQHY-P250YHM-A(For Ground source)
1 7
Inverter scroll hermetic compressor
Inverter
6.3
0 0 . 3 5 2 ( 4 0 ) V
M E L 3 2
Acrylic painted steel plate
1,160(1,100 without legs) x 880 x 550
45-11/16(43-5/16 without legs) x 34-11/16 x 21-11/16
High pressure sensor, High pressure switch at 4.15MPa (601 psi)
Over-heat protection, Over-current protection
Over-heat protection
R410A x 5.0kg (12lbs)
195(430)
p a l e t y t p e
5.0
1.0
-
9.52(3/8) Brazed
2 2 ( 2 . / 7 ) 8 B a r e z
KE94C317
red to the Installation Manual.
Unit converter
kcal
BTU/h
cfm
lb
*The specification data is
subject to rounding variation.
d
=kW x 860
=kW x 3,412
3
=m /min x 35.31
=kg / 0.4536