Master/Slave Operation; Remote Control - EuroLite AKKU Mini PARty User Manual

Rgbw spot mk2

Hide thumbs

Table of Contents

Available languages

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled with the

master unit without the need for a DMX controller. The devices must be set to the corresponding operating modes.

Configure all slave units before connecting the master unit by setting the DMX start address in menu DMX

d to 1.

Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX

output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been connected in

a chain. Do not connect a DMX controller to the DMX input of the master unit.

Set the master unit to the desired operating mode (color mode or effect program). The interconnected devices

will now operate in sync.

When actuating a button, always hold the remote control in the direction of the sensor at the control unit's front or

rear. A direct line of sight between the remote control and the sensor is required. The IR remote control will only

work in stand-alone mode, it will not work in DMX or slave mode.

Battery

The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery

contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil from

the battery support on the rear side of the remote control. Otherwise operation of the remote control is not possible.

If the range of the remote control decreases, replace the battery. For this purpose, on the

rear side of the remote control press the small bar with the groove to the right and at the

same time remove the battery support. For operation, one 3 V button cell type CR 2025 is

required. When inserting, pay attention that the positive pole of the button cell shows

upwards in the support