Operation; Stand-Alone Mode; Master/Slave Operation - EuroLite 51914226 User Manual

OPERATION

After connecting the device to the mains it is ready for operation. The display lights up and you can choose
the desired mode via the buttons MENU, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board and the
EUROLITE IR-38 remote control or in DMX-controlled mode via a standard DMX controller.

Stand-alone mode

In stand-alone mode, the device can be used without controller. Disconnect the device from the controller
and call up the menu you want to use. Please refer to the instructions under Control Board.

Master/slave operation

Several devices may be interconnected. Then all slave units can be synchronized and controlled with the
master unit without the need for a DMX controller. The devices must be set to the corresponding operating
modes.
1
Set the master device to the mode Master. Set the slave mode Slave on every slave device. Please
refer to the instructions under Control Board.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX
controller to the DMX input of the master unit.
3
The interconnected devices will now operate synchronously.
27/36 00147068, Version 1.0