Master/Slave Operation; Dmx Operation - EuroLite IP AUDIENCE BLINDER User Manual

Master/slave operation

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit. For this, set each Slave device to the same
DMX address (for example 001) and confirm with ENTER.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX
controller to the DMX input of the master unit.
3 Set the master unit to the desired program under Automatic Mode. The interconnected devices will
now operate synchronously.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 12 control channels.
However, it can also be switched to a mode with 4, 6 or 8 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until A001 is indicated on the display. Confirm with the ENTER
button. Via the UP/DOWN buttons you can set the desired starting address. Confirm with the ENTER
button.
2 The display now indicates the choices for the DMX channel mode: CH4 (4 DMX channels), CH6 (6 DMX
channels), CH8 (8 DMX channels) or CH12 (12 DMX channels). Use the buttons UP and DOWN to
select the desired DMX channel mode. Confirm with the ENTER button.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed to the
same address, they will work synchronously.
24/28 00148383, Version 1.0