Table of Contents
Advertisement
OTHER KEY FEATURES
How to Sync Transmitter with HomeLink
If programming for the first time, begin with step 1 (repeating
this step will delete all information).
To program non-rolling and rolling code garage door openers
and other devices:
1. Press and hold the left
simultaneously until the indicator light begins to flash (to
reprogram buttons, skip this step)
2. Press and hold the desired button
the button on the transmitter while it is approximately 1 to
3 inches away from the mirror. The HomeLink
light will flash rapidly once the frequency signal has been
successfully programmed
To finish programming rolling code garage door openers,
complete these steps:
3. Locate the "learn" or "smart" button on the garage door's
motor head unit. Press and release the button and complete
step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink
button up to three times
Operating HomeLink
Press one of the programmed HomeLink
Erasing programmed buttons:
Press and hold the left
simultaneously for approximately 20 seconds, and then
release both buttons within 30 seconds.
ALWAYS CHECK THE OWNER'S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
F
and center
G
buttons
F
,
G
or
:
®
buttons.
®
F
and center
H
buttons
®
Quick Tips
- You can reprogram a single HomeLink
- Erasing programmed buttons will delete all
If your garage door opener was manufactured in 2011
or later, and you are unable to program your vehicle's
HomeLink
HomeLink
www.HomeLink.com or call (800) 355-3515.
H
and hold
indicator
®
®
repeating step 2
trained transmitters
system, you may need to purchase a
®
Repeater Kit. For more information, go to
®
*IF EQUIPPED
®
button by
45
Advertisement
Table of Contents
