Table of Contents
Advertisement
STEERING WHEEL CONTROLS
Windshield Wipers & Washers
To operate:
Move lever up/down to change wiper modes
§
MIST: Single wipe
OFF: Wiper off
AUTO: Auto Rain Sensing
Pull to spray and wipe
§
Auto Rain Sensing
The rain sensor located on the upper end of the windshield
glass senses the amount of rainfall and controls the wiping
cycle for the proper interval. The more it rains, the faster the
wiper operates. When the rain stops, the wiper stops.
To turn ON the auto rain-sensing wipers, move lever up/down
to AUTO.
To adjust the auto rain-sensing wiper speed setting, move
the speed control switch
LCD Controls and Modes
The LCD modes
B
on the instrument cluster can be
changed using the control buttons
the steering wheel.
Press Mode buttons / to change LCD mode.
Press Move buttons
Press Select/Reset button
For more detailed information, see the LCD Instrument Cluster Modes section on page 6.
ALWAYS CHECK THE OWNER'S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
LO: Slow wipe
HI: Fast wipe
A
up/down.
C
on the right side of
/ to select item.
in center to set/reset the item.
A
AUTO RAIN-SENSING
WINDSHIELD WIPERS
VIDEO
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to page 2
for more information.
Quick Tips
- When the ENGINE START/STOP button is in the
- Set the wiper to the OFF position when the wiper
- If going through a car wash, remind the
B
C
www.KuTechVideos.com/kh13/2017
ON position and the wiper switch is in AUTO
mode, the wiper will automatically operate once
to perform a self-check of the system
is not in use
attendant to keep the vehicle in Neutral (N)
and keep the engine running. Also, disable the
Power Trunk lid control using the button inside
the glove compartment, turn off the auto rain-
sensing wipers and fold in the mirrors
17
*IF EQUIPPED
Advertisement
Table of Contents
