Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bartscher F 90
Summary of Contents for Bartscher F 90
- Page 1 F 90 - F 130 104609 - 104636...
- Page 2 Bartscher GmbH Phone: +49 5258 971-0 Franz-Kleine-Str. 28 Fax: +49 5258 971-120 Technical Support Hotline: +49 5258 971-197 D-33154 Salzkotten Germany www.bartscher.com Version: 1.0 Date of preparation: 2021-11-29 Bes chr eibung...
- Page 5 Quick Start Guide TOUCH Operation status LED indicator status every 30” Standby every 10” Storage container full every 0.5” Production cycle start Ice production ON 5” + OFF Alarm blackout ON 3” + OFF Cleaning cycle In case of alarm: 1.
-
Page 7: Table Of Contents
Original instruction manual Safety ......................2 Explanation of Signal Words ..............2 Safety instructions..................3 Intended Use ................... 5 Unintended Use ..................5 General information ..................6 Liability and Warranty ................6 Copyright Protection ................6 Declaration of Conformity ................ 6 Transport, Packaging and Storage .............. -
Page 8: Safety
Safety Diese Bedi enungsanlei tung besc hrei bt di e Installation, Bedi enung und Wartung des Geräts und gilt als wic htige Infor mationsquelle und N achschl agewer k. Di e Kenntnis aller enthaltenen Sic herheits hinweis e und H andlungs anweisungen schafft die Vorauss etz ung für das sichere und s ac hger echte Ar beiten mit dem Gerät. D arüber hi naus müs sen die für den Ei ns atz ber eic h des Geräts geltenden ör tlichen Unfall verhütungs vorsc hriften und allgemeinen Sicherheits besti mmungen eing ehalten wer den. Dies e Bedi enungs anleitung is t Bes tandteil des Produkts und muss i n unmi ttelbarer N ähe des Ger äts für das In¬s tal l ations-, Bedi enungs-, Wartungs- und R einigungspers onal jederzeit z ugänglich auf¬bewahrt werden. Wenn das Ger ät an eine dritte Pers on weiterg egeben wird, muss die Bedi enungsanlei tung mit ausgehändigt wer den. -
Page 9: Safety Instructions
Safety WARNING! The signal word WARNING warns against hazards that may lead to moderate or severe injuries or death if the hazards are not avoided. CAUTION! The signal word CAUTION warns against hazards that may lead to light or moderate injuries if the hazards are not avoided. , di e IMPORTANT! The signal word IMPORTANT indicates possible property damages,... - Page 10 Safety • Always completely unwind the power cord. • Never place the appliance or other objects on the power cord. • Always take hold of the plug to disconnect the appliance from the power supply. • Check the power cord regularly for damage. Do not use the appliance if the power cord is damaged.
-
Page 11: Intended Use
Safety • Unintended or prohibited use may cause damage to the appliance. • The appliance may only be used when its technical condition is flawless and allows for safe operation. • The appliance may only be used when all connections are executed according to rules of law in force. -
Page 12: General Information
General information General information Liability and Warranty All information and instructions in this instruction manual account for legal regulations in force, current level of technical engineering knowledge as well as our expertise and experience, developed over the years. If special models or additional options are ordered, or state-of-the-art technical solutions were implemented, the actual scope of delivery of the appliance may, in some circumstances, differ from descriptions and numerous drawings in this instruction manual. -
Page 13: Transport, Packaging And Storage
Transport, Packaging and Storage Transport, Packaging and Storage Delivery Check Immediately upon reception, check the delivery for completeness and possible shipping damage. In the case of visible transport damage refuse to accept the appliance or accept it conditionally. Mark and note the scope of damage in shipping documents/consignment list of the shipping company and lodge a complaint. -
Page 14: Technical Data
ON/OFF switch / control key • Indicator light • Can be integrated • The set includes: 1 ice shovel Ice-Flake Maker F 90 Name: 104609 Art. No.: Material: CNS 18/10 Storage container capacity, in kg: Max. production, in kg per 24 hours:... -
Page 15: Functions Of The Appliance
Technical Data Ice-Flake Maker F 130 Name: 104636 Art. No.: Material: CNS 18/10 Storage container capacity, in kg: Max. production, in kg per 24 hours: Coolant, amount in kg: R290 / 0,070 Climate class: GWP index: Water connection: 3/4" Water outlet, Ø in mm: Connected load: 0,69 kW | 220-240 V | 50 Hz Dimensions (W x D x H), in mm:... -
Page 16: List Of Components Of The Appliance
Technical Data List of Components of the Appliance 1. Housing 2. Storage container lid 3. Water drain opening 4. Flake ice outlet opening 5. Storage container 6. Front cover 7. Power cord with mains plug 8. Water connection 9. Drain port 10. -
Page 17: Installation And Operation
Installation and operation Installation and operation Installation CAUTION! Incorrect installation, positioning, operation, maintenance or misuse of the appliance may lead to personal injury or property damage. Positioning and installation, as well as repairs may be performed by authorised technical service only and in compliance with the applicable national law. - Page 18 Installation and operation – sufficiently large, and thus enabling usage of the appliance with no problems; – easily accessible; – well ventilated. • The appliance may be loaded and unloaded with a forklift truck or a pallet truck, with the length of over half of the length of the appliance. •...
- Page 19 Installation and operation • Level the appliance (Fig. 3). If the appliance is not levelled, it may negatively affect its functionality, as well as water supply. Water Connection 1. Install the appliance near a water connection. ATTENTION! Connect the appliance only to a supply connection of potable water. Otherwise install a water purification appliance.
-
Page 20: Operation
Installation and operation • The electric circuit between the appliance and the power supply connection should be equipped with a suitable multi-polar disconnecting device (Fig. 7), which is capable of providing distance of contact opening rendering full separation possible in the conditions of overvoltage category III. •... - Page 21 Installation and operation Look at the pic tur es: Remove the c over after removi ng the fasteni ng screws. Unloc k the gear motor, slats and float (if pr esent) by removing the factor y-fitted stops to avoid damage. Switching-On 1.
- Page 22 Installation and operation 3. To reduce the share of humidity in flake ice, press the control key until it changes its colour to white. If the control key is not pressed during 5 seconds, the entered setting will be saved and the appliance will leave the change phase (Fig.
- Page 23 Installation and operation • Depending on the season (summer or winter), the probe may change the maximum produced amount of ice. To change the probe setting, follow the indication in chapter 'Setting Probe in Storage Container'. Operation Status / Alarm Status Indicators The control key features the combination of white and red colour;...
-
Page 24: Cleaning
Cleaning Red LED White LED Indicator / Alarm indicator indicator (AL20) Augur motor thermal alarm 2 / 1 x 3.0" 6 x 0.5" (AL22) Hall sensor alarm 2 Upload/download HACCP data — software blinks 3x blinks 3x update Start-up phase blinks, 2 Hz Ice production phase Storage container full... -
Page 25: Cleaning
Cleaning Cleaning User Cleaning 1. At the end of each working day, as well as after a long period without operating the appliance, clean the appliance thoroughly. 2. Clean the housing with a soft cloth, moistened with a chlorine-free stainless steel cleaning agent. -
Page 26: Possible Malfunctions
Possible Malfunctions Water Inlet Filter The water inlet filter must be regularly cleaned, observing the blow indications: – close the water shut-off valve; – unscrew water supply tube; – use tweezers to pull the water inlet filter from the socket at the inlet of the solenoid valve;... - Page 27 Possible Malfunctions Malfunction Appliance Condition Solution Alarm (AL04) Appliance stops Check if ohm value is correct. If not, replace the probe. If you Damaged storage check free space in the storage container probe container first, you may produce alarm ice for subsequent 30 minutes by touching the control key.
- Page 28 Possible Malfunctions Malfunction Appliance Condition Solution Alarm (AL08) Damaged evaporator Check evaporator probe connection to PCB probe or outside Condenser probe allowable range; (if available) Check if the measured ohm value appliance stops is correct; if not, exchange the probe (AL09) Appliance re-start in the Check electric connections and...
- Page 29 Possible Malfunctions Malfunction Appliance Condition Solution Alarm (AL11) Appliance stops and Check the water drain tube for clogging regularly attempts a Water discharge certain number of times pump alarm Check water discharge pump to drain water operation Check if the level sensor is clean Check water drain opening of the drain pan (AL14)
- Page 30 Possible Malfunctions Malfunction Appliance Condition Solution Alarm (AL18) Appliance stops Check water supply Evaporator low Check the appliance for loss of temperature the coolant Check evaporator probe location (AL19) Appliance stops Check thermal wiring of the augur (CN13 contact) Augur motor thermal alarm 1 Check if the motor operates Check if ice blocks hinder rotation...
- Page 31 Possible Malfunctions Malfunction Appliance Condition Solution Alarm (AL21) Appliance stops Check Hall sensor for wiring and direction of rotations Hall sensor alarm 1 Check Hall sensor for location Check Hall sensor for connection with PCB (AL22) Appliance stops Check Hall sensor for wiring and direction of rotations Hall sensor alarm 2 Check Hall sensor for location...
-
Page 32: Disposal
Disposal Disposal Electrical Appliance Electric appliances are marked with this symbol. Electrical appliances must be disposed of and recycled in a correct and environmentally friendly manner. You must not dispose of electric appliances with household waste. Disconnect the appliance from the power supply and remove power cord from the appliance.