1 — Installation of the UMAP 2110
1.2.8 Console Port (COM)
The Console interface (COM) on the front panel is the main control interface of the UMAP 2110.
The RJ45 connector pin assignment is illustrated below:
1 2 3 4 5 6 7 8
To connect the host PC to the console port, a RJ45 (male) connector-to-RS232 DB9 (female)
connector cable is required. The RJ45 connector of the cable is connected to the COM port of the
DSLAM; the DB9 connector of the cable is connected to the PC COM port. The pin assignment of
the console cable is shown below:
14 / 54
Figure 1-10 Console Port RJ-45 pin assignment
DB-9F
Pin 2 RD
Pin 3 TD
Pin 5 DGND
Figure 1-11 Pin Assignment of Console Cable
3
4
TX
RX
RJ-45M Pin
1
2
3
4
5
6
7
8
6
Other pins
GND
unused