Mounting The Umap 2110; Figure 1-2 Mounting Bracket Orientation (Top View) - Titan UMAP 2110 Hardware Installation And User's Manual

1 — Installation of the UMAP 2110

1.2.2 Mounting the UMAP 2110

The position and orientation of the brackets depends on the rack used for mounting. The DSLAM
can be front-mounted in a standard channel rack (5-inch projection); and it can be shipped with the
mounting brackets installed in one of three mounting positions or shipped loose (see Figure 1-2).
The mounting brackets can be rotated for use in wall mounting. Optional adhesive feet may be
attached to the bottom of the chassis so that it can be placed on a desk or other smooth surface.
MOUNTING
BRACKET
After the site requirements have been verified, the chassis may be installed at the specified location.
When mounting the chassis, practice good safety habits. Use two or more people to secure the
chassis. Relay rack mounting normally requires at least two people.
Step
1 Locate the chassis and obtain the appropriate chassis mounting hardware.
2 Determine and obtain the tools required for the chassis mounting hardware.
3 From the front of the relay rack, position the chassis in its relay rack mounting location.
4 Using the appropriate rack mounting hardware, secure the chassis in its relay location on
both left and right side of mounting bracket (see Figure 1-3).
Note — The chassis should be empty during the chassis mounting procedures. Remove any unit in
the chassis, and store them according to static-sensitive device storage procedures.
Warning — Hazardous voltages may exist on the chassis. Always practice good safety habits
when wiring a live circuit or performing maintenance.
6 / 54
FRONT MOUNT

Figure 1-2 Mounting Bracket Orientation (Top View)

STANDARD
FRONT
Action
MOUNTING
BRACKET