Setting The Top Of Form (Tof) /Esc~B - Citizen PD 22 PD-22 PD-22 Command Reference Manual

Setting the top of form (TOF) /ESC~B

n2
[Decimal]
[Hexadecimal]
[Parameter]
[Description]
● For setting, only binary data are acceptable.
m = 1: Setting the normal form feed
3. Setting the form feed at marker detection
● Sets the feed rate for auto feeding. The feed rate for normal operation and marker detection can be set.
● Calculation unit for n1, n2 is dot (1 dot=1/8mm). Setting value: "n1+(n2×256)dot".
● The set values are stored in the flash memory and remain effective even after the power is off.
● Do not use this command together with other print commands because it writes data into the flash memory.
● When setting a feed rate for marker detection, be sure to set a value greater than the mark width (ESC~e).
● After data are stored in the flash memory, the printer power is automatically turned OFF. The set values become
effective when the power is turned ON again.
● Default value for form feed is set at 95 in normal operation and 194 in black mark detection.
● Setting check
Setting can be checked by specifying m=255.
ESC ~ 255 0: Prints the setting
ESC ~ 255 1: Returns the setting (only when the cable interface is used).
(Print result)
VTOP
VTOP (EYEMARK): 194
(Return result)
[Hexadecimal packet]
FB ？？ ？？ ？？ ？？
* *
１ ２
*1: Return start code
*2: Form feed setting rate in normal operation (word length)
*3: Form feed setting in black mark detection (word length)
* The form feed setting for normal operation is used when auto feed operation is set to enable in the internal
setting of the printer. The form feed setting for marker detection is used when black mark operation is set
to enable in the internal setting of the printer. Refer to the section on internal settings of printer.
[ASCII]
27 7E 66
1B 126 42
m = 1, 3
m = 255: Checking the setting rate
: 95
*
３
ESC ~
m n1 n2
m n1 n2
7
B m n1