Point Detector - Siemens FDUD293 Technical Manual

5.7.1
Building Technologies
Fire Safety

Point detector

Executing commands - general procedure
The internal alarm indicator is set so that it flashes in normal mode.
The adapter cable is not plugged into the service device.
1. Select the desired command on the service device, for example the '2.1 Check'
menu item.
2. Guide the service device to the detector. See figure. Use a telescope rod if
necessary.
3. Turn service device clockwise until detector snaps into place in service device.
See figure.
4. Read command result off LEDs and display.
Executing commands on a point detector
See also
Deviation list [
Executing commands - general procedure [
Executing commands - general procedure
41]
Operation 5
28]
29
009718_e_en_--
2014-04-11