Inserting And Removing Detectors - Siemens FDUD293 Technical Manual

5 Operation

Inserting and removing detectors

5.5 Inserting and removing detectors
26
Building Technologies
Fire Safety
The service device does not have to be switched on to insert and remove
detectors.
Inserting the detector
1. Place detector in service device so that it snaps into place. There are four
possible positions.
2. Guide service device and detector towards fitted base and insert detector into
base.
3. Turn clockwise until detector snaps into place in base.
4. Pull service device straight down.
The detector is inserted in the base.
Removing the detector
1. Guide service device towards detector.
2. Turn service device clockwise until detector snaps into place in service device.
3. Turn service device and detector anti-clockwise until detector comes loose
from base.
4. Guide service device and detector down.
The detector is removed from the base.
009718_e_en_--
2014-04-11