Sony SRP-L300 Operating Instructions Manual page 18

18
!º EXPANDER On/Off
This parameter sets the expander/gate ON/OFF operation.
ON / OFF
!¡ EXPANDER Attack
This parameter sets the attack time of the expander/gate operation.
0.1 to 1000 [msec]
!™ EXPANDER Hold
This parameter sets the hold time of the expander/gate operation.
47 to 4700 [msec]
!£ EXPANDER Release
This parameter sets the release time of the expander/gate operation.
47 to 4700 [msec]
!¢ EXPANDER Side EQ
An equalizer is used for the trigger signal of the expander/gate operation. This
parameter sets the frequency sensitivity of the expander/gate operation.
!¢-1 EXPANDER Side EQ Type
This parameter selects the type of equalizer.
OFF / HPF / LPF / BPF / PEAKING
!¢-2 EXPANDER Side EQ Frequency
This parameter selects the frequency of an equalizer.
The frequency of an equalizer cannot be set when the type of equalizer is OFF.
200/250/315/400/500/630/800/1k/1.25k/1.6k/2k/2.5k/3.15k/4k/5k/6.3k/8k/
10k/12.5k/16k [Hz]
!¢-3 EXPANDER Side EQ Level
The level of an equalizer is set when the type of equalizer is PEAKING.
It cannot be set when the type of equalizer is other than PEAKING.
–10/–8/–6/–4/–2/0/+2/+4/+6/+8/+10 [dB]
∗ Q of a bandpass filter is 4.0.
∗ Q of a peaking filter is 1.0.
∗ The sync switching in the three parameters of an equalizer is collectively carried
out by "Type."
!∞ EXPANDER Threshold
This parameter sets the level in which the expander/gate operation is initiated.
The gain is reduced in a level of less than the set level
–10 to –90 [dBFS] (in units of 1 dBFS).
!§ EXPANDER Ratio
This parameter sets the compression ratio of expander/gate operation.
1.0 to 16 [1:]
!¶ EXPANDER Maximum Gain Reduction
This parameter sets the maximum attenuation value (dB) during expander/gate
operation.
The gain of more than this value is not reduced irrespective of the setting of other
parameters
–2 to –60 [dB] (in units of 2 dB).