Sony SRP-L300 Operating Instructions Manual page 14

6-1. Input Block
Parameter
14
The input block selects input signals and adjusts the level of the input signals.
{
CH-1
ANALOG INPUT
CH-2
{
CH-1
DIGITAL INPUT
CH-2
1D-IN Level
1 D-IN Level
This parameter sets the adjustment of a digital input level
–30.0 dB to +12.0 dB (in units of 0.5 dB).
2 Input Select
This parameter selects input signals.
Analog Normal
Digital Normal
Ana + Dig Normal
Analog CH-1
Analog CH-2
Analog Mono Mix
Digital CH-1
Digital CH-2
Digital Mono Mix
The "INPUT" indicator on the panel lights corresponding to the selected input signal.
3 Input Level
This parameter sets the last level adjustment after input signals are selected
– ∞, –60.0 to 0.0 dB (in units of 0.5 dB).
3Input Level
2Input Select
An analog input signal is used.
A digital input signal is used.
Analog and digital input signals are mixed for use.
(The signals in CH-1 and CH-2 are mixed with each other.)
The analog input signal in CH-1 is input to both CH-1 and
CH-2 of a main block for use.
The analog input signal in CH-2 is input to both CH-1 and
CH-2 of a main block.
The analog input signals in CH-1 and CH-2 are mixed and
input to both CH-1 and CH-2 of a main block for use.
The digital input signal in CH-1 is input to both CH-1 and
CH-2 of a main block for use.
The digital input signal in CH-2 is input to both CH-1 and
CH-2 of a main block for use.
The digital input signals in CH-1 and CH-2 are mixed and
input to both CH-1 and CH-2 of a main block for use.
TO MAIN BLOCK
CH-1
TO MAIN BLOCK
CH-2
}
TO INPUT LEVEL METER