Sony SRP-L300 Operating Instructions Manual page 9

3-2. Rear Panel
R
1 ANALOG INPUT terminals (CH-1 and CH-2)
Analog audio signals are input to the ANALOG
INPUT terminals.
(The terminal is XLR-3-31.)
Electronic balancer circuit
(1: GND, 2: HOT, 3: COLD)
2 ANALOG STACKING terminals (CH-1 and CH-
2)
The ANALOG STACKING terminals are directly
connected to the ANALOG INPUT terminals. These
terminals are used to input the analog input signal
of the SRP-L300 to other equipment.
(The terminal is XLR-3-32.)
Electronic balancer circuit
(1: GND, 2: HOT, 3: COLD)
3 ANALOG OUTPUT terminals (CH-1 and CH-2)
The analog signals after signal processing are output
from the ANALOG OUTPUT terminals.
(The terminal is XLR-3-32.)
Electronic balancer circuit
(1: GND, 2: HOT, 3: COLD)
4 DIGITAL IN terminal
Digital audio signals based on the AES/EBU format
are input to the DIGITAL IN terminal.
(The terminal is XLR-3-31.)
7
5 4
PUSH
THRU IN
REMOTE(RS-232C) DIGITAL I/O
3
6
PUSH
OUT CH-2 CH-1 CH-2
ANALOG OUTPUT ANALOG INPUT
5 DIGITAL THRU (digital through output)
terminal
The DIGITAL THRU terminal is used to input the
digital input signal of the SRP-L300 directly to other
equipment.
Since signals are output through an internal buffer,
they can also be input to multiple SRP-L300s via
series connection.
However, no signal is output when the power is
turned off. (The terminal is XLR-3-32.)
6 DIGITAL OUT terminal
The digital signal after signal processing is output
from the DIGITAL OUT terminal.
The digital output signal conforms to the AES/EBU
format.
The sampling frequency is 48 kHz.
(The terminal is XLR-3-32.)
Note
For more details of the digital input and output, refer to
the "Digital Input and Output" in Section 10.
7 REMOTE terminal
The REMOTE terminal is used to control the
SRP-L300 from a remote location using a personal
computer.
Use an RS-232C signal of 9600 bps during
communication (9-pin D-sub (male)). This connecter
is adapted for PC remote terminal with cross cable.
Please consult a Sony dealer for the communication
protocol.
2
1
PUSH
CH-1 CH-2 CH-1
STACKING
9