Sony SRP-L300 Operating Instructions Manual page 23

6-5. Level Meter Display
Selection of level meter type
The level meter is displayed on the liquid-crystal display (LCD) screen.
The scale has been printed on the frame of the screen.
In =
The level meter of the SRP-L300 is a peak meter based on a digital signal.
It has a peak hold function of about one second. Moreover, the level meter with contents
below can be switched and displayed.
(For the fetch position of each level, refer to the diagram for signal processing.)
INPUT LEVEL (Display IN)
Displays the level of an output signal (signal input to a main block) in the input
block.
The level is displayed in units of dB with the digital full scale as standard.
OUTPUT LEVEL (Display OUT)
Displays the level of an output signal in the output block.
The level is displayed in units of dB with the digital full scale as standard.
Dynamics Gain Reduction (Display DGR) Displays the total level of the gain
reduction in a compressor and expander only when a (A) DYNAMICS
algorithm is used.
The GR segment on the right end lights when gain reduction of less than 1 dB
occurs.
Limiter Gain Reduction (Display LGR) Displays the level of the gain reduction in a
limiter only when a (A) DYNAMICS algorithm is used.
The GR segment on the right end lights when gain reduction of less than 1 dB
occurs.
The displayed level meter is selected by rotating the "SELECT" knob in the default
display state.
(A) DYNAMICS algorithm
In (INPUT)
↑ ↓
Out (OUTPUT)
↑ ↓
DGR(Dynamics Gain Reduction)
↑ ↓
LGR(Limiter Gain Reduction)
↑ ↓
In (INPUT)
P01 DYNAMICS(A)
-
30 27 24 21 18 15 12 9
LIMITER / DELAY
SELECT
− +
PUSH ENTER/YES
(B) DAL-1000 algorithm
(C) Tap delay algorithm
In (INPUT)
Out (OUTPUT)
CH-1
CH-2
6 3 1 OVER/GR(dB)
↑ ↓
23