Table of Contents
Advertisement
The clereance height between the inferior part
of the cooker hood and the hob must be 650
mm ( some models can be fitted at a lower
height from the hob, please refer to the installa-
tion paragraph).
Unpacking
The fittings supplied to install this cooker
hood can be found with the instruction book
inside the packaging and consists of the following:
Wall/suspended fixing template
Plastic rawl plugs (2)
Fixing screws (4)
Wall Fitting
The cooker hood is fitted to the wall using the
keyhole slots in the back of the hood.
1.
Mark the position on the wall for the screw holes
as illustrated in the drawing inside the documen-
tation.
2.
Check that the hole distances are correct and
are level using a spirit level.
3.
At this stage it is important to allow 25mm (1")
clear space above the cooker hood to enable it
to be hooked onto the screws and for subse-
quent removal for decorating or servicing.
4.
Insert the screws and tighten to a distance of
5mm.
12
Advertisement
Table of Contents
