Table of Contents
Advertisement
The Initial Setup wizard allows you to configure system information, date and time settings, and network settings.
The Initial Setup wizard settings are presented on three windows. Buttons at the bottom of each window allow you to
apply or skip the settings on that window. If you skip settings, you can complete them later by running the Initial Setup
wizard again. To display details about the settings in the windows, click the question mark icon in the bottom right.
Before you begin
Log in to Storage Advisor Embedded, and then open the maintenance utility by clicking the gear icon at the top-right
corner and selecting User Administration.
Procedure
1. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
TipInitial Setup Wizard is near the bottom of the navigation tree. If you do not see this selection, scroll down the
tree.
2. At the bottom, click Skip this step two times to bypass the Set Up System Information and Set Up Date & Time
screens.
3. In the Set Up Network Settings screen, enter the IPv4 or IPv6 configuration settings for the production network to
which the storage system will be connected. For example:
https://knowledge.hitachivantara.com/Documents/Storage/VSP_E_Series/93-04-0x/Installation/Installing_your_VSP_E590_an...
Updated: Thu, 06 Jan 2022 00:49:25 GMT
Powered by
10
Hide quick links:
Advertisement
Table of Contents
