Setting Up The Onix 110; Installing The Battery; Turning On For The First Time; Acquiring Satellite Information - Bushnell ONIX 110 Instruction Manual

Charging the ONIX 110 Battery
Before using your ONIX 110 for the first time, the
internal rechargeable battery must be fully charged,
via the USB port on the unit. Connect the supplied
USB cable to the ONIX 110, then connect the other
end of the cable to the AC Charger. Plug the charger
into an AC wall outlet, and allow the unit to charge
until the battery charge icon on the unit's display
indicates a full charge (this typically takes 4-5 hours).
Once fully charged, disconnect the AC charger and
USB cable, storing them for future use. The USB
cable is also used for data transfer between the ONIX
110 and a PC computer, using the PC Companion
software included on the CD-Rom (see "Installing the
PC Companion" on pg. 45).

Turning On For the First Time

To turn on your ONIX 110 Handheld GPS Navigator,
press and hold the Power button for two seconds. The
product information page is displayed.
Next, the Mode Selection menu appears. Use the
navigation keys to select the mode you want and
press the OK button to confirm.
Press the Menu button twice and select Satellite.
The ONIX 110 starts acquiring satellite information as
described in the following section.

Acquiring Satellite Information

The satellite page displays information obtained from
the GPS satellites (Fig. 1). The upper half of the screen
displays the satellites found in the vicinity and their
respective numbers.
NOTE: In order to operate each mode at its optimal
performance, the ONIX 110 must have its position
determined by the satellites.
Fig. 1
14