ATD Tools ATD-12555 Operating Instructions

ATD-12555
5-in-1 Preset Torque Wrench
OPERATING INSTRUCTIONS
WARNING:
birth defects or other reproductive harm. Wash hands after handling.
Made in Taiwan to ATD Tools, Inc. Specifications
Visit us at www.atdtools.com
ATD Tools, Inc. Wentzville, MO 63385
1. Pull back the adjusting locking knob
to unlock the handle.
2. Turn clockwise or counter-clockwise to set
the desired torque.
3. Push back the adjusting locking knob
to lock the handle.
1. While setting the desired torque, the arrow must line
up with the scale before pushing back the adjustment
locking knob, otherwise it may damage the inner
mechanism.
nuts/fasteners.
3. Never use your torque wrench to apply more torque
Revised January, 2017
than it's rated capacity. This will affect the calibration.
4. Apply a steady force to the center of handle, and stop
STOP
California to cause cancer and birth defects or other reproductive harm.
Wash hands thoroughly after handling.
property damage.
CERTIFICATION
This torque wrench was calibrated prior to shipment from the factory within
tolerance limits of +/- 3% clockwise (right handed) accuracy of upper 80%
of range.
LIMITED WARRANTY
Until one year from the date of purchase, we will repair any defect in
material or workmanship free of charge. Improper use of these products,
including but not limited to the application of excessive force, will affect
performance and may result in injury. The warranty does not apply to
wrenches which do not function properly or within specified accuracy because
of wear, improper or unreasonable use, damage not resulting from defect
or malfunction, or which have been altered. Calibration is warranted for 90
days. This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state. For repair or calibration send
wrench, postage prepaid, to:
ANGLE REPAIR SERVICES, INC.
175 ANGLE DRIVE
BECKLEY, WEST VIRGINIA 25801
304-253-5729