Figure 15 Pc Card Slots On The Nokia 50I - Nokia 50i Installation Manual

4
Installing and Replacing the Flash Memory PC Card
! Initial gateway configuration
Operating system booting
!
The default boot order is:
1. External flash memory (PC card)
2. Internal flash memory
You can only boot from slot 1, even if you use two cards. To boot from the
flash memory card, the card needs to be in slot 1 (the top slot) already before
and during the reboot. You can install the cards in either of the PC slots,
which are accessible from the front of the gateway, as shown in the following
figure.
Note
Use the top PC slot for optimum electrostatic discharge protection.

Figure 15 PC Card Slots on the Nokia 50i

To install and remove the flash memory PC card
1. Insert the flash memory card into PC card slot 1, if it is available.
If slot 1 is occupied, use slot 2.
2. Press gently on the card until it is firmly seated in the slot.
The eject button to the right of the slot should be flush with the card.
3. To remove the card, slowly push the eject button located to the right of the
card.
44
Slot 1
Eject buttons
Slot 2
Nokia 50i Installation Guide
00024