Connecting Network Interfaces - Nokia 50i Installation Manual

Hide thumbs Also See for 50i:
Table of Contents

Advertisement

Connecting Network Interfaces

Nokia 50i has four built-in dual-mode 10 Mbps and 100 Mbps ports
You can connect one network interface to the network to use as the Nokia IP
VPN Gateway interface. You configure this interface during the system
startup procedure, which is described in the Nokia IP VPN Gateway
Configuration Guide.
You can also connect the remaining LAN and WAN interface cables at this
point, although you are not required to do so.
After the power is turned on, the Ethernet link LEDs on the gateway and on
remote equipment illuminate to indicate the connection. As data is
transmitted, the activity LEDs on the gateway illuminate.
Ethernet Cables
Use IEEE 802.3 10 Base-T, 100 Base-TX CAT-5 unshielded twisted-pair
CAT-5 Ethernet cables.
To connect Ethernet devices:
!
!
Nokia 50i Installation Guide
Use a straight-through RJ-45 cable to connect to a 10-Mbps or 100-Mbps
hub or switch.
Use a crossover RJ-45 cable to connect directly to a host.
Connecting Network Interfaces
39

Advertisement

Table of Contents
loading

Table of Contents