Software Setup; Energy Saver Mode - Bunn Crescendo Installation & Operating Manual

Software Setup for Through Counter Option
1. Power the machine.
2. In the PROGRAM mode, use the LARGE cup, (button "A"), to navigate to the "LOCKS/DISABLES" menu.
3. Press the button under "YES" (button "B") and then the LARGE cup size, (button "A"), until the screen displays the
"PUCK BIN" screen.
4. In the default menu, "YES" will be flashing. Press the button under "NO" to disable the PUCK BIN mode.
5. When "NO" is flashing on the display, press the button under "EXIT" to return to the main screen.
6. Place the NORMAL/PROGRAM/RINSE switch to the NORMAL position.
In this mode, the machine will operate in a low power mode during off hours to save energy. The display backlight
will be turned off, and the display message will toggle between "Energy Saver/Mode Enabled" and "Change to Normal/
Mode to Clear". The dispense buttons are disabled so that no beverage dispensing is allowed. The tank refill and powder
(soluble) tank heater are disabled. The espresso tank temperature setting is reduced to 130ºF (54ºC).
To enable the Energy Saver mode:
1. In PROGRAM mode, press the LARGE cup button (button "A"), to navigate to the "LOCKS/DISABLES" menu.
2. Press the button under "YES" (button "B") and then the LARGE cup size, (button "A"), until the screen displays
"ENERGY SAVER?".
3. In the default menu, "NO" will be flashing. Press the button under "YES" to enable the Energy Saver mode.
4. When "YES" is flashing on the display, press the button under "EXIT" to return to the main screen.
5. Place the NORMAL/PROGRAM/RINSE switch to the NORMAL position.
To place the unit in the ENERGY SAVER mode:
1. Open the door, and place the NORMAL/PROGRAM/RINSE switch in the RINSE position.
2. After ten minutes with the switch in the RINSE position, the ENERGY SAVER mode will become active.
NOTE: If a rinse cycle has taken place, and the switch is left in the RINSE position, the ENERGY SAVER mode
will become active ten minutes after the rinse cycle was completed. To exit the ENERGY SAVER mode, return the
NORMAL/PROGRAM/RINSE switch to the NORMAL position.
THROUGH COUNTER OPTION

ENERGY SAVER MODE

17