Touchless Sensitivity Selection Options - Bunn Crescendo Installation & Operating Manual

TOUCHLESS SENSITIVITY SELECTION OPTIONS

The Sensitivity option is available for both TOUCH and TOUCHLESS operation modes. The recommended
initial setting for TOUCH is "NORMAL", and the recommended initial setting for TOUCHLESS is "HIGH".
NOTE: Your Crescendo must be fitted with a Gen 2 PCAP with software version 01.20 or higher, and the
main I/O board with software version 00.45 or higher to modify the Touch Settings on this machine.
Go to www.bunn.com to view Crescendo Programming Manual or BUNN Online Learning Center for
more information on updating.
STEP 1
• Set the toggle switch on inside
of the door to Program mode.
TOUCH SETTINGS
EXIT YES
Use to
Select
STEP 4
• Press YES to enter the TOUCH
SETTINGS sub-menu.
OPERATING CONTROLS AND INTERFACE
PROGRAM MODE
PRESS TO ENTER
STEP 2
• Advance to the Calibration
screen.
TOUCHLESS MODE
NO
Use to
Select
STEP 5
• Press YES to enable
TOUCHLESS dispense mode.
• Or, press NO to enable TOUCH
dispense mode.
• Press large cup to navigate to
next option screen.
Use to
Navigate
YES
Use to
Select
14
CALIBRATION
EXIT YES
Use to
Select
STEP 3
• Press YES to enter the
Calibration sub-menu.
• Navigate through the sub-menu
until you see a screen that says
TOUCH SETTINGS.
SENSITIVITY
NORMAL HIGH
Use to Use to
Select Select
STEP 6
• Select the sensitivity level for
the TOUCHLESS or TOUCH
mode chosen on previous screen.
NOTE: It is recommended to
try "Normal" for TOUCH and
"High" for TOUCHLESS.
• Press large cup to navigate to
next option screen.
continued >