5.2 Power supply and signal
Red
Power supply
Blue
Ground
White
Signal
5.3 Adjust zero point
5.3.1 CE WTY1 and CE WTY2
After connecting the transmitter and load cell, the user could reset the transmitter if it
displays incorrectly.
Open the transmitter and find the only potentiometer without silica gel. The zero
adjustment of the transmitter could be completed by adjusting the 5K potentiometer.
Please note that all 100Ohm potentiometers are sealed with silica gel, which means
that the user was NOT allowed to make any adjustments to them.
Please DO NOT adjust any components of the product, as
CE WT-BA-e-2010.docx
Connect the wires to the
appropriate power supply
and your evaluation device
12V or 24V DC depending on model
Depending on model
5