Receiver Unit - Delta DE212-2S GLOBAL DSD Operation And Installation Manual

The LB red LED is active only when the transmitter is activated. By pressing the Stop- button, the
battery can be tested during active transmission.
The Stop button, or PANNIC button, turns off the functions in the transmitter and sends an active
STOP, turning instantly off all the functions activated in the receiver. When the PANNIC button is
pressed, the output PANNIC/ STOP is activated giving an intermitted output to give a warning to the
operator. This PANNIC situation is reset by a second press for 2 seconds, ot the Stop/PANNINC
button. Then the system is now ready for normal operation.
If the deadman button is stuck, and the Stop-button is pressed, the transmitter can not be operated
again before the damaged button or switch is changed. Transmitter operation in low temperatures,
lower than -20C can be performed, but not for a long period of time. The transmitter must be warmed
and charged at temperatures higher than 0C when not in use.
Under normal use, the battery lifetime is 2-3 years.
2.2.2
R
ECEIVER UNIT:
Charge contacts
Charge station
ON
The receiver front has a charging station for the transmitter unit, two LED indicators and one
push button marked "CODE".
The energy charged to the battery, is calculated according to the time the transmitter have been used.
This will ensure high capacity and reduced overcharging of the battery.
The CH LED has three stages when the transmitter is placed to charge:
1. CH is dark. No action.
2: CH burns continues. Full charge current.
3: CH flashes. Indicates trickle charging, battery is full according to the last operation.
The green light diode, marked ON, indicates that a correct voltage is supplied and the receiver is ready
for operation. When coding the receiver and transmitter, this green LED flashes three times when the
code is accepted and stored in the receiver.
When the receiver is in operation, receiving an accepted telegram from transmitter, the yellow CH
LED is flashing rapidly.
D RC AS
ELTA
User and Installation Manual, DE212-2S DSD
CODE button
RX, CH, Charge
Page 12 of 24
Document 02481