Locating Components - Gateway MX6633 Hardware Replacement Manual

Replacing the Wireless
Network Module
By law, only approved wireless modules
provided by Gateway, or a Gateway authorized
Caution
representative, explicitly for your notebook may
be installed in this notebook.
You need a small Phillips screwdriver to replace
Tools the wireless network module.

Locating Components

Wireless
network bay
Preventing static electricity discharge
The components inside your notebook are extremely sensitive
to static electricity, also known as electrostatic discharge (ESD).
ESD can permanently damage electrostatic discharge-sensitive
components in your notebook.
To avoid exposure to dangerous electrical
voltages and moving parts, turn off your
notebook and unplug the AC adapter, modem
Warning
cable, and network cable before replacing a
component.
Before working with notebook components, follow these
guidelines:
• Avoid static-causing surfaces such as carpeted floors,
plastic, and packing foam.
• Remove components from their antistatic bags only when
you are ready to use them. Do not lay components on the
outside of antistatic bags because only the inside of the
bags provide electrostatic protection.
• Always hold components by their edges. Avoid touching
the edge connectors. Never slide components over any
surface.
• Wear a grounding wrist strap (available at most electronics
stores) and attach it to a bare metal part of your workbench
or other grounded connection.
• Touch a bare metal surface on your workbench or other
grounded object.
Technical Support
See the label on the bottom of the notebook for Customer
Care Information. See your hardware guide for important
safety, regulatory, and legal information.
Replacing the wireless network module
To replace the wireless network module:
1 Follow the guidelines under "Preventing static
electricity discharge."
2 Turn off your notebook.
3 Disconnect the AC adapter, modem cable, and
network cable.
4 Disconnect all peripheral devices and remove any
PC Cards.
5 Turn your notebook over so the bottom is facing up,
then remove the battery. For more information, see
"Changing Batteries" in your online hardware guide.
6 Loosen the wireless network bay cover screw (this
screw cannot be removed), then remove wireless
network bay cover.
Screw
7 Unplug the two antenna cables.
8 Move the antenna cables out of the way.
© 2006 Gateway, Inc. All rights reserved. Gateway and
eMachines are trademarks or registered trademarks of
Gateway, Inc. in the United States and other countries.
All other brands and product names are trademarks or
registered trademarks of their respective companies.
www.gateway.com
Replacing the Wireless Network Module
1