Replacing The Keyboard - Gateway MX6633 Hardware Replacement Manual

Replacing the Keyboard

You need a small Phillips and a small flat-blade
Tools screwdriver to replace the keyboard.
Preventing static electricity discharge
The components inside your notebook are extremely sensitive
to static electricity, also known as electrostatic discharge (ESD).
ESD can permanently damage electrostatic discharge-sensitive
components in your notebook.
To avoid exposure to dangerous electrical
voltages and moving parts, turn off your
Warning notebook and unplug the AC adapter, modem
cable, and network cable before replacing a
component.
Before working with notebook components, follow these
guidelines:
• Avoid static-causing surfaces such as carpeted floors,
plastic, and packing foam.
• Remove components from their antistatic bags only when
you are ready to use them. Do not lay components on the
outside of antistatic bags because only the inside of the
bags provide electrostatic protection.
• Always hold components by their edges. Avoid touching
the edge connectors. Never slide components over any
surface.
• Wear a grounding wrist strap (available at most electronics
stores) and attach it to a bare metal part of your workbench
or other grounded connection.
• Touch a bare metal surface on your workbench or other
grounded object.
Removing the old keyboard
To remove the old keyboard:
1 Follow the guidelines under "Preventing static
electricity discharge."
2 Turn off your notebook.
3 Disconnect the AC adapter, modem cable, and
network cable.
4 Disconnect all peripheral devices and remove any
PC Cards.
5 Turn your notebook over so the bottom is facing up,
then remove the battery. For more information, see
"Changing Batteries" in your online hardware guide.
Technical Support
See the label on the bottom of the notebook for Customer
Care Information. See your hardware guide for important
safety, regulatory, and legal information.
6 With a small Phillips screwdriver, remove the
keyboard screw and put it in a safe place.
Tips & Tricks
Memory
bay
Wireless
network
bay
7 Loosen the six memory bay cover screws and one
wireless network bay screw (these screws cannot be
removed), then remove the bay covers.
8 If your notebook has the two optional keyboard
screws, remove them.
Screw
9 Turn your notebook over so the top is facing up.
10 With a small Phillips screwdriver, remove the two
hinge cover screws and put them in a safe place.
Screw
11 Insert the small flat-blade screwdriver under the
bottom of each hinge cover and gently pry it up.
12 Carefully open the LCD panel to the fully opened
position.
© 2006 Gateway, Inc. All rights reserved. Gateway and
eMachines are trademarks or registered trademarks of
Gateway, Inc. in the United States and other countries.
All other brands and product names are trademarks or
registered trademarks of their respective companies.
www.gateway.com
Replacing the Keyboard
The keyboard screw hole is marked with a K.
Keyboard
screw
Screw
Screw
1