Battery Test Results - Midtronics MDX-650 Instruction Manual

6.
or DOWN ARROW button to increase the scrolling speed.
Press ENTER to start test. After several seconds the tester displays the
7.
sion on the battery's condition and the measured voltage. The tester also
displays your selected battery rating and the rating units.
Decision

Battery Test Results

Decision
GOOD BATTERY
GOOD-RECHARGE
CHARGE & RETEST
REPLACE BATTERY
BAD CELL-REPLACE
24 VOLT SYSTEM
READY TO INSTALL
NEEDS CHARGE
Scroll to and select the rating units. Hold down the UP
Return the battery to service.
Fully charge the battery and return it to service.
Fully charge the battery and retest. Failure
to fully charge the battery before retesting
may cause inaccurate results. If CHARGE &
RETEST appears again after you fully charge the
battery, replace the battery.
Replace the battery and retest. A REPLACE
BATTERY result may also mean a poor
connection between the battery cables and the
battery. After disconnecting the battery cables,
retest the battery using the out-of-vehicle test
before replacing it.
Replace the battery and retest.
24-volt system detected. Disconnect batteries
and test individually.
Battery has just been activated and is ready to
install in vehicle (Motorcycle only)
Fully charge battery and retest using BEFORE
DELIVERY. (Motorcycle only)
Failure to fully charge the battery before
retesting may cause false readings.
11
•
Interpretation
•
MDX-650P
Battery Conductance &
System Analyzer
deci-
Measured
voltage
Measured
CCA
Selected
rating
www.midtronics.com