Battery Test Results; New Battery Test Results - Midtronics MDX-600 Series Instruction Manual

BATTERY RATING: Scroll to and select the rating units. Hold down the UP
5.
or DOWN ARROW button to increase the scrolling speed.
Press ENTER to start test. After several seconds the tester displays the
6.
sion on the battery's condition and the measured voltage. The tester also
displays your selected battery rating and the rating units.

Battery Test Results

Decision
GOOD BATTERY
GOOD-RECHARGE
CHARGE & RETEST
REPLACE BATTERY
BAD CELL-REPLACE
24 VOLT SYSTEM
READY TO INSTALL
NEEDS CHARGE

New Battery Test Results

Besides the standard battery test results new battery has two more:
CYCLING REQUIRED Battery needs to be cycled for optimal
REST & RETEST
Return the battery to service.
Fully charge the battery and return it to service.
Fully charge the battery and retest. Failure
to fully charge the battery before retesting
may cause inaccurate results. If CHARGE &
RETEST appears again after you fully charge the
battery, replace the battery.
Replace the battery and retest. A REPLACE
BATTERY result may also mean a poor
connection between the battery cables and the
battery. After disconnecting the battery cables,
retest the battery using the out-of-vehicle test
before replacing it.
Replace the battery and retest.
24-volt system detected. Disconnect batteries
and test individually.
Battery has just been activated and is ready to
install in vehicle (Motorcycle only)
Fully charge battery and retest using BEFORE
DELIVERY. (Motorcycle only)
Failure to fully charge the battery before
retesting may cause false readings.
performance.
Battery could have a surface charge, because it
has recently been charged.
12
• •
Interpretation
www.midtronics.com
deci-