Trouble Shooting - Parkside PWD 25 A2 Translation Of The Original Instructions

GB IE

Trouble Shooting

Problem
Device does not start
Low or lack of suction
Float does not switch
the appliance off
Dust or dirt is blow out
of the device
26
Possible cause
Mains voltage is not
present
Defective on/off switch (3)
Worn carbon brushes
Defective motor
Hose system (16) or jets
(22/23/24) blocked
Suction pipe (14)
assembled incorrectly
Container (5) open
Container (5) full
Filter (18/20/21) full or
clogged
Float in the filter basket
( 25) does not move
Float in the filter basket
( 25) faulty
Float in the filter basket
( 25) does not move
Float in the filter basket
( 25) faulty
Filter (18/20/21) is not or
not correctly assembled
Fault correction
Check plug socket, cable,
line, plug and fuse, where
appropriate, repair through
electrical specialist
Repair by Customer Care
Remove obstructions and
blockages
Assemble suction pipe correctly
Close container
Empty container
Empty, clean or replace filter
Release float
Repair by Customer Care
Release float
Repair by Customer Care
Use missing filters or check the
correct position of the filter