Table of Contents
Advertisement
Safety instructions
Electrical
Your Argon ultrasonic cleaning system is designed to be connected to a 415VAC 3P+N+E
protected (fuses, MCBs) type supply.
Connection to a 400-415VAC (3P+N+E) supply may be hard wired or via a 5 pin, 16/32A,
red BS4343 plug and socket (rating dependant on unit requirements).
It is dangerous to operate your ultrasonic bath without a connection to mains earth.
Ensure that excess mains cable is stored neatly.
General use
Ensure that the tank contains liquid before you switch it on.
Always use a basket to support items to be cleaned.
Not doing so may damage the ultrasonic cleaning system and invalidate your warranty.
Do not place hands or fingers in the tank.
Care should be taken when operating the ultrasonic cleaning system at higher
temperatures as external surfaces may become hot.
Never use toxic, flammable, acidic, caustic or corrosive solutions in the Argon Series.
Do not move the ultrasonic cleaning system when it is full of water.
Read the whole of these instructions. Safety may be impaired if they are not followed.
Ultrawave will not be responsible for damage or injury caused by incorrect use of the
equipment.
WEEE Compliance
Ultrawave is complying with the WEEE regulations by contracting our obligations to a
Producer Compliance Scheme. Once it is deemed that this ARGON ultrasonic cleaning
system is no longer effective, please contact Ultrawave to arrange collection by our
compliance scheme provider, who will pick up the machine from your premises.
2
Advertisement
Table of Contents
