Connecting The Ac Adapter - Gateway 200E Reference Manual

Connecting the AC adapter

You can run your notebook using an AC adapter or your
notebook's main and optional secondary batteries. The
battery(ies) were shipped to you partially charged. You should
use the AC adapter right away to fully charge the battery(ies).
Allow three hours for the battery(ies) to fully charge.
user-replaceable or user-serviceable parts inside. The AC adapter has dangerous
voltages that can cause serious injury or death. Contact Gateway about
returning defective AC adapters.
or one of the same type purchased from Gateway. Replace the power cord if
it becomes damaged. The replacement cord must be of the same type and
voltage rating as the original cord or your notebook may be damaged.
you use your notebook on battery power for the first time, the battery life may
be much shorter than you expect. If the battery life seems short even after being
charged for three hours,
information on recalibrating
on page
To connect the AC adapter:
1
16
CHAPTER 3: Setting Up and Getting Started
Warning
Do not attempt to disassemble the AC adapter. The AC adapter has no
Caution
Make sure that you use the AC adapter that came with your notebook
Important
If the main and optional secondary batteries are not fully charged before
the battery(ies)
the battery(ies),
61.
Connect the power cord to the AC adapter.
may need to be recalibrated. For
see "Recalibrating the battery(ies)"