Tarmo TAR1225 Instruction Manual page 31

Essential elements of snow blower (see Fig. 1):
A body (Pos. 1), rotor and a mechanism controlling the flaps position (pos. 6). The flaps con-
trolling depending on the model and version of the snow blower can be mechanical or hy-
draulic via cylinders. The body is a steel compact construction that combines the rotor hous-
ing, parts the three-point hitch linkage to the tractor, scraping arms to which scraping
blades (pos. 5) are mounted. Three sliding supports (pos. 9) (two lateral and one rear) with
adjustable extensions are attached to the body. They are designed to adjust the height of
snow removing. The rotor consists of the auger (pos. 2) and ejector (pos. 3) having four eject-
ing blades. The whole is mounted on the shaft (pos. 4) via bearings. A mechanism controlling
the flaps position consists of a lever, a set of tie rods, cable and spring (see Catalogue of
spare parts, table A and figure A). It is used to direct the snow exhaust stream to the right or
to the left side.
Fig. 1
NOTE!
Snow blower is protected against damages with four screws M12x40-8.8-II. Two screws
tighten the auger with ejector, and the other two tighten rotor shaft with the ejector. In a
case of breaking one of the bolts pairs, they must be replaced with new one. They should
have the same parameters (spare safety bolts are screwed to the bracket on the rear wall of
ejector housing). Do not use placeholders instead of spare parts provided by manufacturer.
31