Safety Instructions - Tarmo TAR1225 Instruction Manual

INTRODUCTION
Congratulations for choosing this high-quality TARMO product! We hope it will be
of great help to you. Remember to read the instruction manual before using the
appliance for the first time in order to ensure safe usage. If you have any doubt or
problems, please contact your dealer or the importer. We wish you safe and
pleasant work with this appliance!

SAFETY INSTRUCTIONS

READ THESE INSTRUCTIONS CAREFULLY AND NOTE THE SAFETY INSTRUCTIONS
AND WARNINGS. USE THE APPLIANCE CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
TO PROPERTY AND/OR SERIOUS PERSONAL INJURY. KEEP THIS INSTRUCTION
MANUAL SAFE FOR FUTURE USE.
- The machine should be operated, serviced and repaired only by adults (persons over 18
years) with valid driving license for tractors and familiarized with its specific characteris-
tics, and with the rules of conduct for safety.
- Rules for the prevention of accidents, all basic rules of safety and occupational health as
well as road traffic regulations must always be observed.
- Unauthorized changes made to the machine without the permission of the manufacturer
may exempt a manufacturer from liability for any resulting damage or injury.
- You should check the machine and the tractor in terms of traffic and operation safety be-
fore each use.
- Mount the machine according to the rules and join only the recommended devices of the
tractor.
- Pay attention to the warnings in crushing and shearing places while start the machine up.
- Pay special attention during attaching machine to and disconnecting from the tractor.
- The travelling speed must always be adapted to the environmental conditions. Avoid un-
expected turns while travelling on uneven ground (e.g. hills) crossing the mountains and
valleys, and along the mountain slopes.
- The machine inertia shall be taken into account when passing on curves.
- The machine can be started up only when all the safety devices are placed in securing
position.
- Check the machine for loose parts before starting work.
- The presence of other people near the running machine is prohibited.
- There are the crushing and shearing zones, where some parts must be operated by using
additional force – be careful.
- Any malfunctions of attached elements (the machine, lighting system) remove only when
the drive on the machine working parts is switched off, tractor engine is off, parking
brake is engaged and the ignition key is removed.
- Lower the machine to the ground, turn the drive and the tractor engine off and remove
the ignition key before leaving the tractor. Engage the handbrake and secure the machine
from unauthorized start.
- No one can stand between the tractor and the machine until the vehicle will be secured
against self-rolling off by a fixed brake or a wedge.
- Permissible slope inclination at work and transportation is 8,50.
- Do not work with a snow blower on a downhill slope.
- The speed limit of 15 km/h must not be exceeded.
24
EN