Page 1
• Mounts a screen and a dome camera from the ceiling • Max load: 25kg (screen) / 5kg (camera) • Available in two Ø38mm pole lengths: BT5964-FD100 pole length 1000mm BT5964-FD200 pole length 2000mm • Recommended for screens up to 47”...
CONTENTS Installation Safety Notes........................Parts List..............................Installation Instructions........................Product Dimensions..........................B-Tech Contact Details........................INSTALLATION SAFETY INSTRUCTIONS CAUTION: This mount is intended for use only with the maximum weights indicated. Use with equipment heavier than the maximum indicated may result in instability causing possible injury. Do not attempt to install this product until all instructions and warnings have been read and properly understood.
Page 4
BT5964 PARTS LIST PLEASE KEEP THIS FOR FUTURE REFERENCE...
INSTALLATION INSTRUCTIONS MOUNT CEILING PLATE TO CEILING i. Pre-drill holes for ceiling fixings (not supplied). ii. Assemble two fixing screws on opposite sides, leaving a 10mm gap between the screw head and ceiling. iii. Hook item 1 onto the fixing screws and twist into position. Leave 10mm gap to hook on ceiling plate CEILING...
Page 7
FIX POLE TO CEILING PLATE i. Insert item 4 into item 1 and secure in place with item 2. ii. Tighten item 3, fixing item 4 to item 1. iii. Fit item 5 to item 1. CEILING Note: Align ceiling CEILING plate hole with the hole on the pole.
Page 8
FIX CAROUSEL INTERFACE TO POLE i. Attach item 16 to the bottom of item 4 using item 2. ii. Tighten item 3, securing item 16 to item 4. Note: Align the hole on the carousel interface with the hole on the pole. ATTACH CAMERA TO CAROUSEL INTERFACE Fix the camera to item 16 using items 17 -22.
Page 9
FIX INTERFACE PLATE TO SCREEN a. For screens with VESA fixings: 75 x 75mm, 100 x 100mm or 200 x 100mm Attach item 11 to the rear of screen. using the screen fixing kit. SCREEN b. For screens with VESA fixings: 200 x 200mm i.
Page 10
HOOK SCREEN ONTO MOUNTING PLATE Using item 12, hook item 11 onto item 10. Note: Ensure that items 12 (attached to item 11) have an approx. 5mm gap to allow it to hook onto item 10. SCREEN 5mm approx. SECURE SCREEN TO MOUNT Set screen tilt and secure mount by adding a rear set of items 12 &...
Page 12
B-Tech AV Mounts is a division of B-Tech International Design and Manufacturing Ltd. B-Tech AV Mounts and the B-Tech logo are registered trade marks. All other brands and product names are trademarks of their respective owners. Photographs are for illustrative purposes only. E&OE. AMA-BT5964-V1.1-0821-110 MADE IN VIETNAM For More Information Visit www.btechavmounts.com...